Brake Installation Manual Audi A4

Be aware that brake fluid may leak from line once disconnected. 8. Disconnect ABS sensor grommet from mounting bracket by pulling straight up. 11.Place the pad sensor plug in the small opening on the upright. 12.With a zip tie included in the kit, secure the plugs placement by zip tying it tightly to the ABS wire that is also running through the upright. Using a deep well socket, remove the 17mm bolts on the back side of the caliper and remove caliper.

16.Install the APR caliper mounting bracket with the fl at side facing the outside of the vehicle and tighten with a 17mm deep well socket. 25.Install the banjo end of the APR brake line onto the caliper. Keep in mind the final orientation of the brake line as shown in the picture to the left. Note: See Brake Line Diagram for banjo fitting assembly. 3.During the bleeding sequence you will be replacing your existing brake fluid with new better performing brake fluid.