Free Online Auto Repair Manuals Download

Turn the headlight switch to the position to turn on the headlights All other lights remain on HIGH BEAM Push the headlight switch forward to select the high beam function The blue indicator light illuminates Pull the headlight switch back to the original position to select the low beam.

The blue indicator light goes off Pull and release the headlight switch to flash the headlight high beams on and off TURN SIGNAL SWITCH Move the headlight control switch up or down to signal the turning direction When the turn is completed the turn signals cancel automatically To signal a lane change move the headlight control switch up or down to the point where the indicator light begins to flash but the headlight control switch does not latch FOG LIGHT OPERATION if so equipped Note The headlights must be on and the low beams selected for the fog lights to operate Turn the switch to the position to turn on the fog lights Turn the switch to the OFF position to turn off the fog lights WINDSHIELD WIPER WASHER SWITCH The ignition switch must be in the ON position to activate the windshield wipers Move the lever to the following positions to operate the windshield wipers 1A 04 1B 05 Intermittent INT Front wipers operate intermittently and can be further adjusted by twisting the time control ring 1B Low Speed LO Continuous low speed operation of front wipers High Speed HI Continuous high speed operation of front wipers Mist MIST Lift the lever up for one sweep of the front wipers Rear Wipers REAR Twist the end section to operate the first INT or second ON speed settings for the rear wipers 1A 02 03 02 03 04 05 The washer function activates the washer fluid and several sweeps of the wipers For FRONT WASHER pull lever toward you For REAR WASHER push lever away from you HILL DESCENT CONTROL SWITCH if so equipped The hill descent control system is designed to reduce driver workload when going down steep hills The hill descent control system helps to control vehicle speed so the driver can concentrate on steering the vehicle To activate the hill descent control system The automatic transmission selector lever must be in forward or reverse gear The 4WD switch must be in the 4L position and the vehicle speed must be under 15 MPH 25 km h or The 4WD switch must be in the 4H position and the vehicle speed must be under 21 MPH 35 km h and The hill descent control system switch must be on The hill descent control indicator light will come on when the system is activated Also the stop tail lights illuminate while the hill descent control system applies the brakes to control vehicle speed To turn off the hill descent control system push the switch to the off position The hill descent control system is temporarily disabled when the brake or accelerator pedal is depressed.