Free Online Auto Repair Manuals Download

Free Automotive Owners Manual Nissan Quest 2005. The ignition lock is designed so the key cannot be turned to LOCK position and removed until the shift selector lever is moved to the P Park position When removing the key from the ignition make sure the shift selector lever is in the P Park position If the selector lever is not returned to P Park position the key cannot be moved to the LOCK position.

When the key cannot be turned to the LOCK position proceed as follows to remove the key Starting and driving 5 5 REVIEW COPY 2005 Quest van Owners Manual USA English nna 07 21 04 debbie BEFORE STARTING THE ENGINE NISSAN VEHICLE IMMOBILIZER SYSTEM NVIS The NISSAN Vehicle Immobilizer System NVIS will not allow the engine to start without the use of the registered NVIS key If the engine fails to start using the registered NVIS key it may be due to interference caused by another NVIS key an automated toll road device or automated payment device on the key ring Restart the engine using the following procedures 1 Leave the ignition switch in the ON position for approximately 5 seconds 2 Turn the ignition switch to the OFF or LOCK position and wait approximately 10 seconds 3 Repeat step 1 and 2 again 4 Restart the engine while holding the device which may have caused the interference separate from the registered NVIS key If this procedure allows the engine to start NISSAN recommends placing the registered NVIS key on a separate key ring to avoid interference from other devices Make sure the area around the vehicle is clear Check fluid levels such as engine oil coolant brake fluid and window washer fluid as frequently as possible or at least whenever you refuel Check that all windows and lights are clean Visually inspect tires for their appearance and condition Also check tires for proper inflation Lock all doors Position seat and adjust head restraints Adjust inside and outside mirrors Fasten seat belts and ask all passengers to do likewise Check the operation of warning lights when the key is turned to the ON 3 position See Warning indicator lights and audible reminders in the Instruments and controls section of this manual WARNING Never remove or turn the key to the LOCK position while driving The steering wheel will lock This may cause the driver to lose control of the vehicle and could result in serious vehicle damage or personal injury KEY POSITIONS LOCK Normal parking position 0 OFF Not used 1 ACC Accessories 2 This position activates electrical accessories such as the radio when the engine is not running ON Normal operating position 3 This position turns on the ignition system and the electrical accessories START 4 This position starts the engine As soon as the engine has started release the key It automatically returns to the ON position 5 6 Starting and driving REVIEW COPY 2005 Quest van Owners Manual USA English nna 07 21 04 debbie STARTING THE ENGINE 1 Apply the parking brake 2 Move the shift selector lever to P Park or N Neutral P Park is recommended The shift selector lever cannot be moved out of P Park and into any of the other gear positions if the ignition key is turned to the OFF position or if the key is removed from the ignition switch The starter is designed not to operate if the shift selector lever is in any of the driving positions 3 Crank the engine with your foot off the accelerator pedal by turning the ignition key to START Release the key when the engine starts If the engine starts but fails to run repeat the above procedure If the engine is very hard to start in extremely cold weather or when restarting depress the accelerator pedal a little approximately 1 3 to the floor and hold it and then crank the engine Release the key and the accelerator pedal when the engine starts If the engine is very hard to start because it is flooded depress the accelerator pedal all the way to the floor and hold it Crank the engine for 5 6 seconds After cranking the engine release the accelerator pedal Crank the engine with your foot off the accelerator pedal by turning the ignition key to START.