Radio Receiver Removal and Installation for Dodge Durango

Radio Receiver Removal and Installation for Dodge Durango

If excessive resistance is found in any ground circuit, clean, tighten, or repair the ground circuits or connections to ground as required before considering any component replacement. Disconnect and isolate the battery negative cable. Remove the two screws that secure the radio receiver to the instrument panel. Pull the radio receiver out from the instrument panel far enough to access the instrument panel wire harness connectors and the antenna coaxial cable connector.

Remove the speed control switch located on the same side of the steering wheel as the remote radio switch that is being serviced. Refer to Speed Control Switches in the Removal and Installation section of Group 8H – Speed Control System for the procedures.