Removal and Installation Guide for 1983 Mazda RX7 Transmission
Removal and Installation Guide for 1983 Mazda RX7 Transmission
Remove solenoid and inhibitor switch connector. Remove speedometer cable. Remove drive shaft. Fit main shaft holder (49 0259 440) into main shaft in transmission case to prevent oil leak. Remove starter and gusset plates. INSTALLATION Reverse removal procedure to install transmission, noting the following: When installing torque converter, be sure that notch in converter lines up with notch in oil pump.
TRANSMISSION SERVICING : Inspect automatic transmission fluid level every 7,500 miles or 8 months. FLUID LEVEL 1) Check fluid with vehicle on level floor. Apply parking brake firmly and run engine approximately 2 minutes at 1200 RPM.
If you enjoyed this post, make sure you subscribe to the feed and get future manuals delivered to your email!
