Supercharger Kit User Manual Honda B16 B18
Supercharger Kit User Manual Honda B16 B18
Removal of parts Remove factory airbox and plastic intake hose. Remove the throttle cable from the intake. Remove all air and water hoses from the intake. Remove all electrical connectors from the intake. Remove the fuel pressure line and fuel return line from the fuel rail. Remove the two bolts underneath the intake (intake bracket). Remove all nuts holding the intake. You should now be able to remove the intake. Now you shall try if the M8 fixing bolt fits through the alternator and the tensioner fixing bracket. If it doesn’t fit you must adjust the position of the two offset plates until the M8 fixing bolt fits.
Throttle install, Remove the two electrical connectors on the distributor. Also remove the metal bracket holding these connectors. The two connectors are repositioned lower down to make room for the throttle body. Secure the connectors with straps. Install a pressure oil hose (6mm) to the supercharger oil fitting. Make sure the hose is clean (clean out with solvent before install), any dirt will clog the spray nozzle and ruin the supercharger.
If you enjoyed this post, make sure you subscribe to the feed and get future manuals delivered to your email!
